Emtek EMTouch Keypad Leversets Locksets Manuel d'utilisateur

ASSA ABLOY, the global leader in door opening solutionsInstallation & Programming GuideEMTouch Electronic Lever Locksets

10In order to perform each of the following six functions, the lock must rst be placed in Programming Mode:*If no input within 20 seconds, Yellow LED

11IN8-EMTOUCHLL 04/14/2011Restoring the Lock to Factory Default Setting• Press and hold EMTEK button for 3 seconds.• Enter “000000”• After 2 beeps

ASSA ABLOY is the global leader in door opening solutions, dedicated to satisfying end-user needs for security, safety and convenience.Copyright © 201

234b24a4c4d5764ITEM NO. DESCRIPTION QTY.1 Key 22 Outside Trim Plate Assembly 13 Latch Assembly 2 ⁄” or 2 ¾” Backset14 Inside Trim Plate Assembly 1

31” Deep2 ⁄” or 2 ¾” Backset2 ⁄” Diameter Bore⁄” Deep2 ¼”1 “1” Diameter Edge Bore3. Remove Screws from Inside Trim Plate2. Door Prep3. Door Jam

4Use a Phillips head screwdriver to remove screws (item #4c) shown below and detach Inside Trim Plate from the Inside Chassis.Screws (item #4c)Step 1:

53. Install Outside Trim Plate AssemblyStep 1: While holding Outside Trim Plate Assembly, Press the Plastic Extender (A) into end of Spindle Shaft (B)

64. Install Inside ChassisCAM LINK MUST REMAIN IN THE CORRECT POSITION DURING INSTALLATION.!Step 1: Conrm the position of Cam Link.For Left Hand Loc

7CHECK ALIGNMENT BEFORE FULLY TIGHTENING SCREWS.!Step 4: Connect Wire Harness (A) and tuck Connectors as shown (B).ABStep 5: Install Battery.For op

8*Locked position is required for installation and removal of the Inside Trim Plate Assembly. (Does not apply to Keypad Storeroom/Gate product) *Lock

9Your Emtek lock is shipped with two 4-digit user codes and a 6-digit programming code. These codes are randomly generated at the factory. (Turn to ne